Hello,
My scenario is straight forward, hope you can help me.Port Fa0/0 of a Cat 2950 is doing trunking 802dot1q and the rest of ports (0/1-0/11) access. Each access port was assigned a different vlan (vlan 2 thru vlan 11 resp).
This is mainly because each port has a special set of users and I must make sure traffic from one port does not be seen into another. (keep it from malicious attacks or whatsoever).
My question is if by configuring PVLAN Protected Ports will be at Layer 2 level on the switch plus configuring ACLs at Layer 3 level on the router.
Wish to hearing your comments at the earliest,
My scenario is straight forward, hope you can help me.Port Fa0/0 of a Cat 2950 is doing trunking 802dot1q and the rest of ports (0/1-0/11) access. Each access port was assigned a different vlan (vlan 2 thru vlan 11 resp).
This is mainly because each port has a special set of users and I must make sure traffic from one port does not be seen into another. (keep it from malicious attacks or whatsoever).
My question is if by configuring PVLAN Protected Ports will be at Layer 2 level on the switch plus configuring ACLs at Layer 3 level on the router.
Wish to hearing your comments at the earliest,