Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
scsi csrd
- Thread starter nabob1
- Start date
KenCunningham
Technical User
Wear (and attach appropriately) an anti-static wriststrap and boot -r from the OK prompt so that the machine picks up the new card. HTH.
Before powering down and while at the ok prompt run this command.
ok show-devs (this will show what is installed-copy this)
power off
insert the new board and do a "stop a" so you can go to the
ok prompt.
ok show-devs (do you see the new board--use the copied info from above)
If you do see the board then boot -r
If you don't see the board then a boot -r will not help!
ok show-devs (this will show what is installed-copy this)
power off
insert the new board and do a "stop a" so you can go to the
ok prompt.
ok show-devs (do you see the new board--use the copied info from above)
If you do see the board then boot -r
If you don't see the board then a boot -r will not help!
- Thread starter
- #4
KenCunningham
Technical User
Not a stupid question. I prefer
shutdown -i0 -g0 -y
to init.
Cheers.
shutdown -i0 -g0 -y
to init.
Cheers.
- Status
Similar threads