S8700 System Logs

[Duaneness]

Is there any way to see what alarm condition was cleared? We're running CM 1.2. When I go into the web interface of the server, then select "View System Logs" under Diagnostics, and select Platform command history log, I can see where alarms were cleared through the inads port. but I can't figure out what alarms were cleared...

Is there any way to find out short of calling Avaya and asking them what they did?

Thanks in advance -

- Duaneness

 

[jlapine]

In ASA run "display alarms" command and change Resolved field to "no". Then use the "list history" command to find the commands that were run to clear the alarms.

 

[Duaneness]

These are server-level alarms that do not show up in the alarm & error log in ASA. I only see them in the logs on the server.

 

[qz01gs]

If you into go shell

almdisplay -res [-v] (display resolved alarms)