Routing incoming Nos

[misterbelly]

Hi all, can you help?

Ayaya 406v22 x bri4s
Software 4.2 GA release
Primary nos are
4 x isdn2s with number 20044200
4 x isdn2s with number 20002100 with a block of 100 Nos.

2004200 routes to hunt group 1
Nos 20002100 to 20002199 route to hunt group 2
When I dial 20002100 it routes to hunt group 1, any other number in the sequence 20002101 to 20002199 routes to hunt group 2, where I want them to go. I cannot for the life of me get 20002100 to route to hunt group 2. When I take 20044200 out of the incoming route 20002100 goes nowhere.
When I place an ISDN telephone onto one of the nt1s. The phone rings.
Any ideas thanks

 

[amriddle01]

Sounds like the incoming numbers are programmed with the wrong incoming line group id

ACS - IP Office Implement

 

[misterbelly]

I have reconfigured the incomings to line 0 and line 2. all nos route ok, except for 20002100. It now goes nowhere that i have change it to a different incoming line no from the other huntgroup.

 

[misterbelly]

this is the error i get on the monitor when i dial 20002100

2857483mS CMTARGET: 1.3.1 33 Q931 Trunk:1 CHAN=1: GetNoAnswerTimer:9


and when i dial 20002101
2857478mS CMTARGET: 1.3.1 33 Q931 Trunk:1 CHAN=1: SelectTargetAvailable 1 targets

 

[amriddle01]

where is the "any voice" route set too?

ACS - IP Office Implement

 

[misterbelly]

Resolved, i removed the incoming CLI field for 20002100 and it has worked. I did not have an incoming CLI no for any of the others. looks like it is an issue with the telecoms provider here in Gib.

Thanks tom