Router Tunnel Interface not showing in Solarwinds

[molecul3]

Hi all,

I am not sure whether this is an appropriate place to ask this question... but i'll try anyway.
I am using Solarwinds Orion for network monitoring purposes. For some reason, when I add a router node to monitor, it shows all interfaces on that router except Tunnel 111. I have 4 tunnels, 100, 101, 110 and 111 on the router and all are up.. but for some reason.. it doesn't show 111 on solarwinds. Anyone know where to start looking? Thanks in advance.

 

[burtsbees]

Post a sh run, and we can compare the tunnel config...

Burt

 

[molecul3]

Thank you for your reply. I have a couple of routers and they all have 4 tunnels with similar configs. Comparing them, I don't find any significance as to why it would not come up in Orion Network Performance Monitor as all the rest come up just fine. I'll keep looking

Regards

 

[burtsbees]

Access list? Inactive tunnel?

Burt

 

[plshlpme]

do you have the same snmp config/mibs on the router in question? im not sure if any of them would be tunnel interface specific...
same ios?

 

[molecul3]

Hi all,

Thanks for the replies.

Burt, there are access lists but nothing specific to that tunnel and the tunnel is indeed active.

plshlpme...its the same IOS as other routers that turned up OK. As for SNMP config... the same as well. How do i go about inspecting the MIBs?

Thanks all.