Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Router sub interface 1

Status
Not open for further replies.

lobo66

IS-IT--Management
Joined
Nov 12, 2002
Messages
106
Location
US
have a 2611 with dual eth 0/0 and eth 0/1

try to connect a trunk to eth 0/0 via a sub interface 0/0.1 but it will not allow me to ecap do1q, is this not possible on a eth int only on a fa port?

THX
 
It was in the correct VLAN prior to.
 
It was in the correct VLAN prior to. I am changing these 3 2611 routers and replacing them with 1841 and I know it works on that series. Going to take the 2611 and use them in my home lab. Will continue researhing it and if I find solution will let you know.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top