handsbogan
Programmer
Anyone know how i should configure this i have cs1000e and two T's with pstn. i want to go out over the second T if the first fails? how do i configure this?
Any help much appreciated!
Any help much appreciated!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
route cost on NRS
- Thread starter handsbogan
- Start date
- Status
EddieDuece
IS-IT--Management
Put them in the same trunk group.
- Thread starter
- #4
handsbogan
Programmer
Sorry need to make clear!
my pstn connectivity is DPNSS to another switch. S0 when i dail an ac1 followered by spn i insert the ac1 again and when dailing exts i do not insert on the DMI but when this goes to the nrs, routing has not failed because the sip trunks are active. it is when you disable the DPNSS on one T it still trys to push the call to that route so you recieve a reject message on the E. how can i make the NRS select the other T to route the failled called?
Thanks
my pstn connectivity is DPNSS to another switch. S0 when i dail an ac1 followered by spn i insert the ac1 again and when dailing exts i do not insert on the DMI but when this goes to the nrs, routing has not failed because the sip trunks are active. it is when you disable the DPNSS on one T it still trys to push the call to that route so you recieve a reject message on the E. how can i make the NRS select the other T to route the failled called?
Thanks
- Status
Similar threads
- Locked
- Question
- Locked
- Question