Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Removing s8300/MM Boards

Status
Not open for further replies.

FFrey

Programmer
Dec 20, 2009
327
0
0
US
We have removed some boards from a few G450 gateways and I am wondering how to remove them from the programming also. For example if I disp media xx I still see the S8300 in Slot V1:. The survivable gateway programming has all been removed but the slot still shows the board. I also have a few MM boards that we will be removing.
 
Login to the active CM through the GUI and remove the LSP there.
 
LSP programming has been removed from the CM but if you run disp media xx, page 2 still shows a S8300 in slot V1:
 
Change media-gateway x, go to page 2 and line it out from slot 1 as long as translations have been removed.
 
Thanks Joe! I knew it would be something simple.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top