Release 24.24 ISDN Gate opener?

[MikeRizz]

I am trying to configure a PRI on an older Option 11. I do not see ISDN in the CDB. It should be with the NET_DATA. I checked and the switch does have package 145 ( ISDN ). It does not have package 233 ( BRIT ). Not sure if it needs it? What I am missing here? Been a while since I worked on one of the old dogs.

 

[bigindian65]

you're correct, should be in Net and be a gate opener, not need a gate opener...

Mato' Was'aka

 

[bigindian65]

it is prompted IF 233, OR at least 1 PRA link is configured.

Mato' Was'aka

 

[MikeRizz]

Mato', I did see that in the NTP's. How do I configure a PRA? Thank you.

 

[bigindian65]

it almost reads to me (??) like if you go build a digital trunk route, and then go back to 15, it will be there

Mato' Was'aka

 

[MikeRizz]

I thought the same thing, no luck. Something is off with this switch. No in-service patch's at all!

 

[MikeRizz]

Very strange, if I print NET_Data it shows ISDN-No, but I can't get it show up when in LD 15 to set it to yes! Before when I printed it, it did not show up at all.

 

[bigindian65]

wow, I've had times like those. Maybe it will show up and let you chg to yes at some point

Mato' Was'aka

 

[hawks]

1 Add a PRI card. “LD 17"
2 Add a DCHI card. “LD 17"
3 Define a PRI customer. “LD 15"
4 Define a PRI service route. “LD 16"
5 Define service channels (B-channels) PRI trunks. “LD 14"
6 Define clock synchronization. “LD 73

 

[johnpoole]

in that rls isdn was no by default in net_data.. i chased that rabbit for hours one night..

ld 21 prt net
ld 15 chg net


john poole
bellsouth business
columbia,sc

 

[bigindian65]

his isdn doesnt show up for the chg John

Mato' Was'aka

 

[MikeRizz]

It did not have package 146, Primary rate access( PRA ). Why it would have the PRI package and not PRA is beyond me! I felt pretty foolish when I finally figured it out.