We are setting up a new T1 – not a PRI – I just want to make sure I have the correct settings for the DS1 and trunk group. These are the settings for the T1 from QWEST:
Wink
Out pulse DTMF
Framing ESF
Line Coding B8ZS
These are the settings I believe to be correct in order for the T1 to work:
DS1 CIRCUIT PACK
Location: 01B09 Name: QWEST T1
Bit Rate: 1.544 Line Coding: b8zs
Line Compensation: 1 Framing Mode: esf
Signaling Mode: robbed-bit
Interface Companding: mulaw
Idle Code: 11111111
Slip Detection? n Near-end CSU Type: integrated
ESF DATA LINK OPTIONS
Network Management Protocol: tabs
Send ANSI-T1.403 One-Second Performance Reports? n
Far-end CSU Address: b
INTEGRATED CSU OPTIONS
Transmit LBO: 0db
Receive ALBO: 26db
Upon DTE LOS: loopback
CPE LOOPBACK JACK OPTIONS
Supply CPE Loopback Jack Power? n
TRUNK GROUP
Group Number: 2 Group Type: tie CDR Reports: y
Group Name: QWSET Long Distance COR: 1 TN: 1 TAC: 202
Direction: two-way Outgoing Display? n Trunk Signaling Type:
Dial Access? y Busy Threshold: 60 Night Service:
Queue Length: 0 Incoming Destination:
Comm Type: voice Auth Code? n
Trunk Flash? n
TRUNK PARAMETERS
Trunk Type (in/out): wink/wink Incoming Rotary Timeout(sec):
Outgoing Dial Type: tone Incoming Dial Type: tone
Wink Timer(msec): 300 Disconnect Timing(msec):
Digit Treatment: Digits:
Sig Bit Inversion: none
Analog Loss Group: 9 Digital Loss Group: 13
Incoming Dial Tone? y
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0 Receive Answer Supervision? Y
TRUNK FEATURES
ACA Assignment? n Measured: internal
Internal Alert? n Maintenance Tests? y
Data Restriction? n
Glare Handling: none
Used for DCS? n
Suppress # Outpulsing? n
Seize When Maintenance Busy: neither-end
Incoming Tone (DTMF) ANI: no Per Call CPN Blocking Code:
Connected to CO? n Per Call CPN Unblocking Code:
Ds1 Echo Cancellation? N
I am not to sure about the DTMF.
Thanks in advance for your input.