Red lights on my DTR cards

[probietech]

We lost power again this morning-- UGH!!! Everything is back up and seems to be running fine, however, I have red lights on my DTR cards- - -is there a way to reset them??

 

[janaya]

did you stat them in the system? Maybe they are just disabled. You can reseat to see if that clears, or just re-enable them in the system.

 

[probietech]

I hate to sound stupid- but do I stat them in ld 60??

 

[bigindian65]

if you know their loop, stat them in 11 or 32
ld 32
.stat x x xx (loop-shelf-card)

Mato' Was'aka

 

[GHTROUT]

DTR's are enabled in LD 34.

.ENLR l s c (u)

--
GHTROUT.com - Help for Nortel Meridian/CS1000 System Administrators
--

 

[telebub]

Not saying you're wrong, but I have always done it in Ld 32 as BigI stated. Only used LD 34 for Conf/TDS cards. Learn something new everyday.

 

[probietech]

what load do I go to that will show me the disabled dtr card- I have reseated the cards and nothing worked

 

[bigindian65]

bigindian65 (TechnicalUser) 24 Jun 10 12:59
if you know their loop, stat them in 11 or 32
ld 32
.stat x x xx (loop-shelf-card)
Mato' Was'aka



Mato' Was'aka

 

[probietech]

THANK YOU SOOOOO MUCH EVERYONE!!!! Finally have everything back up and running!!

 

[GHTROUT]

You "test" DTR's in LD34, so enabling them in LD34 is usualy what follows

LD 34
.DTR 4 0 15

OK
.

--
GHTROUT.com - Help for Nortel Meridian/CS1000 System Administrators
--

 

[telebub]

LD 32
.STAT l s c

.DISC l s c

.ENLC l s c