ChunderPants
Technical User
I have an Cisco Soho 97 with a public IP address. My lan address is a 192.168.x.x I want to RDP to my home pc remotly is this possible. Do I have to configure an access-list or NAT? Cheers
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
RDP access using cisco soho 97
- Thread starter ChunderPants
- Start date
- Status
If you haven't enabled any IP security features, NAT will likely suffice.
Something as follows may do the trick for you:
int ethernet0
ip nat inside
int dialer0
ip nat outside
ip nat inside source static tcp 192.168.x.x 3389 a.b.c.d 3389
where 192.168.x.x is the IP address your internal machine and a.b.c.d is the IP address of your ADSL WAN interface (which I've assumed is Dialer0).
You'll need the following as well of course to allow your internal host to communicate with the outside world:
ip nat inside source list 1 interface dialer0 overload
access-list 1 permit 192.168.x.x 0.0.255.255
Something as follows may do the trick for you:
int ethernet0
ip nat inside
int dialer0
ip nat outside
ip nat inside source static tcp 192.168.x.x 3389 a.b.c.d 3389
where 192.168.x.x is the IP address your internal machine and a.b.c.d is the IP address of your ADSL WAN interface (which I've assumed is Dialer0).
You'll need the following as well of course to allow your internal host to communicate with the outside world:
ip nat inside source list 1 interface dialer0 overload
access-list 1 permit 192.168.x.x 0.0.255.255
- Status
Similar threads
- Locked
- Question