Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Raid1 recovery

Status
Not open for further replies.
zee7

zee7

Technical User
Aug 28, 2003
18
AU
I have Raid 1 cofigured over 2 drives. One of the drives has failed. I have the replacement drive. What steps do I take to recover from this.

Do I put the new drive in and does it auto rebuild's itself?
Thanks
 
Sort by date Sort by votes
Are you running software or hardware raid. If you are running software raid then you will need a Boot disk to make the computer start up. If you have hardware raid then all you need to do is boot and reconfigure the mirror.

Good Luck
 
Upvote 0 Downvote
I replaced the Failed drive. Rebuilt the drive. Created the drive. Formatted the drive. Now the raid is operational Again. It was a Hardware Raid.

Thanks for your help!!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Teo En Ming
  • Locked
  • Question
Actions taken during Disaster Recovery for client whose IBM Megaraid controller has failed
Replies
2
Views
688
fightaccording
fightaccording
joblack23
  • Locked
  • Question
BMR server recovery
Replies
0
Views
150
joblack23
joblack23
slavishrook
  • Locked
  • Question
Unable to use EMC or Powershell when the services for Symantec System Recovery are enabled & run
Replies
1
Views
214
ShackDaddy
ShackDaddy
ceil32
  • Locked
  • Question
Server 2008 R2 - System recovery options - parameter incorrect
Replies
0
Views
227
ceil32
ceil32
kurio71
  • Locked
  • Question
Software for Recovery of Data from Formatted Drive?
Replies
3
Views
138
cmeagan656
cmeagan656

Part and Inventory Search

Sponsor

Back
Top