Question about T1 card on MICS 6.0

[StevenA1]

We want to install a T1 (no PRI) and was wondering if there is any issues with having the MICS at software version 6.0 (30BwE02 NAT) ?

And if there is any real benefit going to 6.1.

Thank you for all your help,

 

[aragon]

The 6.1 MR2 release fixes many issues with PRI that resulted in greater stability of the PRI connection.
6.1 also added support for the T7316E and KIM.

 

[StevenA1]

Thanks for the reply. The T1 we are installing is not PRI, would there be any difference?

Thanks

 

[aragon]

T1's have no real features beyond those of regular analog lines. They also have more issues in regards to individual channels dropping out of service. If any T1's are to be installed then my advice would be to use 6.1 MR2 software.
Stay away from 7.0

 

[MarvO1]

Aragon, what kind of issues have you had with T-1 on 7.0?
All of my new 7.0 installations have been PRI and working fine, but wondering what kind of issues to expect if I have any non-PRI T1's on 7.0?

MarvO said it

 

[aragon]

Marv I am hearing conflicting reports of the stability of the 7.0. Mostly I am hearing that the 7.0 suffers from software corruption and issues with P2P PRI and MCDN networking.
Sounds like MICS 6.0 pre MR2 all over again.

 

[MarvO1]

Ah yup, sure does. Thanks for the info. aragon. Here we go again maybe.

MarvO said it