QSIG PRI delivered from Cisco Router

[Bee77]

has anyone out there implemented a PRI being delivered from a Cisco Router having QSIG on it?
i'm having an issue where the PRI comes up just fine, the D and B-Channels and incoming calls via this "network" work fine, but i can't get a call to route out from this switch in the slightest. The trunks show in-service/idle. I'm using AAR to route the calls, but on the trace, i end up with an off-hook dialing time out denial event. What gives? I've specified the trunk group as service type: tie on the ISDN trunk group with QSIG features enabled, but even without the QSIG features enabled, i'm not able to pass a call out over "the PRI". Has anyone done this out there and can give a couple things to look at as far as either route pattern or something that i forgot or need to check?
-Wes
(wbee@trinetsystems.com)

 

[Bee77]

ok, i figured out what it was. And i'll let you all know in case you ever do this in the future.
i'm translating the trunk group as public type so it looks to the public table to send the name & number like i want it to.
but on the AAR table, i have to specify the call type as lev0. and then after reading some docs on QSIG networking over ISDN-PRI, i learned what options i need to turn on in the trunk group, so i guess the docs do work eh! hehe