AbdulRashid
Technical User
which protocol should i use to connect Hipath 3800 to Hipath 3800 through PRI
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Protocol to connect 3800 to 3800 through PRI
- Thread starter AbdulRashid
- Start date
- Status
If they are directly connected 'back to back' then as long as the protocol is the same there would not be much difference. However I would start with ECMAV2 if it is there, after that Cornet NQ or any other Cornet type.
Make one master and one slave regarding clocking.
Make one master and one slave regarding clocking.
- Thread starter
- #4
AbdulRashid
Technical User
Mr.SBCSU , can I have you email or Skype id.
where do you work? it seems to me you have worked to much on Siemens PABX.
anyway thank you very much for you reply.
where do you work? it seems to me you have worked to much on Siemens PABX.
anyway thank you very much for you reply.
- Status