My scenario is straight forward, hope you can help me. You see, Port Fa0/0 of a Cat 2950 is doing trunking 802dot1q and the rest of ports (0/1-0/11) access. Each access port was assigned a different vlan (vlan 2 thru vlan 12 resp).
This is mainly because each port has a special set of users and I must make sure traffic from one port do not go into another or visceversa. (keep each other from malicious attacks or whatsoever).
My question is if I configured PVLAN Protected Ports at Layer 2 level on the switch, plus ACLs at Layer 3 level on the router, WOULD THIS BE GOOD ENOUGH AS FOR TIGHTENING SECURITY AMONGST THESE PORTS?
Thank you for reading this message,
Best regards,
This is mainly because each port has a special set of users and I must make sure traffic from one port do not go into another or visceversa. (keep each other from malicious attacks or whatsoever).
My question is if I configured PVLAN Protected Ports at Layer 2 level on the switch, plus ACLs at Layer 3 level on the router, WOULD THIS BE GOOD ENOUGH AS FOR TIGHTENING SECURITY AMONGST THESE PORTS?
Thank you for reading this message,
Best regards,