Properly Network MICS's with Point to Point PRI

[SysTool]

I am trying to connect (2) MICS Systems with a Point to Point PRI. Using Rad IP MUX-11's at each site acting as the LEC providing the PRI. MICS at one site is R6.1 and at the other is R7.0. PRI enabler codes are installed. I have sync lights on rad equipment and alarm lights are off. I have checked parameters to match, PRI, ESF, B8ZS etc..., The clocking is set to Primary on both [this may be my biggest reason why not working] I have set up a route, a dest code, target lines. I get a "no lines Free" message when attempting to dial. Anyone ever configure like this with or without the RAD Mux-11's?

 

[johnpoole]

one end has to be seconday

john poole
bellsouth business
columbia,sc

 

[hawks]

What Protocol does the Mux emulate? Also if you move this to the Norstar Forum you will get more hits on it. If this is the only T1/PRI in each system then they would be set to Primary.

 

[SysTool]

Thanks for the replies, How do I move this to the Norstar Forum? The Mux will emulate NI-2 Protocol which is what I selected. This does get a little more complicated wich I didn't want to post and be to complicated off the bat. I actually have 3 sites, 2 point to point T1 PRI's via the Rad MUX-11's (4) total Rad MUX 11's. (2) PRI (DTI) cards in the middle switch. I think I have to set one as Master and the other will automatically configure itself proper as primary or seconday. The remote site I am sure need to be primary and no clocking will come from the RAD Mux's. I will try to send this to the Norstar forum as well. Thank You.

 

[SysTool]

I moved this thread (copied it anyway) to the Norstar Forum. Thank You.