Found a great thread where BuckWheet perfectly outlined the same problem I have: thread690-415874
Did anyone ever come up with the pinouts and the jumpering on the pinouts for this cable? I noticed in the Avaya pinouts that there are several pins not defined and was wondering if anyone figured out the jumpering that is going on?
Any help would be appreciated. I was able to make cable that I needed, I have all the equipment to install the RS-232 connectors and such, but the jumpered pinouts that Buckwheet refers to eludes me and I have the exact same problem with the processor coming up "no board" however the system works fine.
Buckwheet, just so you know, reading your post, I did the EXACT same procedures that you went through, all the way down to the cabinet, bus terms, the whole nine yards.....
Did anyone ever come up with the pinouts and the jumpering on the pinouts for this cable? I noticed in the Avaya pinouts that there are several pins not defined and was wondering if anyone figured out the jumpering that is going on?
Any help would be appreciated. I was able to make cable that I needed, I have all the equipment to install the RS-232 connectors and such, but the jumpered pinouts that Buckwheet refers to eludes me and I have the exact same problem with the processor coming up "no board" however the system works fine.
Buckwheet, just so you know, reading your post, I did the EXACT same procedures that you went through, all the way down to the cabinet, bus terms, the whole nine yards.....