Programming CPND on analog phones 3

[wideawake12]

Is it possible to program analog phones with CPND
In LD95 this is programmed
req prt
type cpnd
cust 0

type cpnd
cust 0
cnfg alon
mxln 27
stal yes
dfln 27
des yes
resn yes
cfwd f
cfna n
hunt b
pkup p
xfer t
aaa a
nitc ni
Can anyone help
Wideawkae12

 

[Firebird Scrambler]

Any Analogue, Digital, ACD, CDN or Route etc can be assigned a name in LD 95.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://mysite.orange.co.uk/firebird_scrambler

Useful Nortel forum at

http://www.tspforum.com

If it's working, then leave it alone!.

 

[bigindian65]

do a new
type NAME

at the dn put in the extension.

Mato' Was'aka

 

[acewarlock]

Also if you had typed

prt
type NAME
cust 0


It would have printed all DN's or you could select just one.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.

 

[wideawake12]

Thanks all was helpful. I have a few 9417CW Nortel telephone was has caller ID. Can I program them to display caller. I follwed instructions in NTP 553-3001-306 Call Party Name Display but got SCH0355.
Name is in LD 95.

 

[acewarlock]

You need a Class Modem Card to display CLID on an Analog phone.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.

 

[wideawake12]

Thank you all for your help.....much appreciated.