Programming a PRI on a CS1000E - TMDI

[terrysdavid]

I know how to program a TMDI on a CS1000S.
However, how do you go about programming a TMDI on a CS1000E. Normally you would have programmed loops in cequ. But seeing that this is a large system I'm not sure how I'm supposed to achieve this. Any suggestions? Thanks

 

[bignose21]

you use dummy numbers so you come up with a number for the PRI that is used for the programming and it will ask you what card it is in MG eg PRI 41 MG 4 0 1


here is a cequ pri example:

DLOP NUM DCH FRM TMDI LCMT YALM T1TE TRSH MG_CARD
PRI 044 24 ESF YES B8S FDL 0 00 004 0 01