Programming a ISDN PRI with VTC connected to ADTRAN 1

[coameno]

I have CS1000E with TMDI cards and trying to connect a VTC that is connected to a ADTRAN Atlas 8330. The PRI's DCH establishes and channels come IDLE but I can't make an in or outgoing call on the system.

Keep getting a unreachable DEST reason 88 on the DCH. Has anyone program one like this. Tried direct selecting the trunk and still get a fast busy. Any sugguestions.

Programmed them as NI2, did trunks and tie sl100 interface same trouble. Lastest dep list on installed.

 

[allenmac]

reason 88 is incompatible destination.

If you are set for VOD, try changing to VCE or 3VCE.

 

[coameno]

We did that, same results, Thanks.

 

[Reusser]

do you get the same reason 88 for incoming and outgoing calls?

might be problem with way call is tagged - NPA, SPN, Unknown, etc

can you post your DCH messages

 

[coameno]

DCH 53 OMSG SETUP REF 00000017 CH 53 23 TOD 10:06:46
CALLING #:3785024 NUM PLAN: PRIVATE/UNKNOWN (UNKNOWN)
CALLED #:2595012 NUM PLAN: PRIVATE/UNKNOWN (UNKNOWN)

PRI222 DCH: 53 DATA: 00000017

DCH 53 OMSG RELEASE REF 00000017 CH 0 TOD 10:06:46

DCH 53 IMSG CALLPROC REF 00000097 TOD 10:06:46

DCH 53 OMSG RELEASE REF 00000017 CH 0 TOD 10:06:46

DCH 53 IMSG CONNECT REF 00000097 TOD 10:06:46

DCH 53 IMSG REL COMP REF 00000017 CH 53 23 TOD 10:06:46
CAUSE :MANDATORY INFO IE MISSING

DCH 53 IMSG REL COMP REF 00000017 CH 0 TOD 10:06:46
CAUSE :INVALID CALL REF VALUE

PRI229 DCH: 53 DATA: 00000000

DCH 53 IMSG SETUP REF 00008001 CH 0 TOD 10:12:02
CALLING #:2595012 NUM PLAN: NUM UNKNOWN/UNKNOWN (UNKNOWN)
CALLED #:945025330071 NUM PLAN: E164/NATIONAL / NPA

PRI227 DCH: 53 DATA: 00000004

DCH 53 OMSG REL COMP REF 00008001 CH 0 TOD 10:12:02
CAUSE :INCOMING CALL BARRED

 

[Reusser]

your outgoing call is tagged unknown - try tagging NPA or NXX

CALLED #:2595012 NUM PLAN: PRIVATE/UNKNOWN (UNKNOWN)


your incoming call is proceded by a 9 - do you intend to have it call back out the switch? if yes, is route built as DID or Tie and does your channels have sufficient NCOS to dial out.

Also, check NET_Data for following prompts:
DITI = yes <-- allow did to tie line connections
FTOP = FRES <-- not used

 

[coameno]

They have 7 digit dialing so the first call is station to stattion. loop 53 is the VTC and they are built as tie. The second call is the access number to an outgoing trunk and the area code and 7 digit number.