Program analog ringdown for emergency phone 3

[Jackman50]

Hello all!
I'd like to know how I would go about programming a ringdown circuit using an analog 2500 port.
Would this also be considered a hotline?
This is on an Avaya 8700 switch.

Thank you..I appreciate anyone's help and/ or input..

Jack

 

[BuckWeet]

you need to make an abbreviated dial list for the station as to where you want it to ring to..

then on the station form there is a spot to program this list when the station goes off hook..


BuckWeet

 

[Jackman50]

Thanks Buckweet,
I appreciate your reply. The phone I'll be using is a dial-less Viking callbox. I chose to order the one without the auto dialer thinking that I'll be able to program the port for auto ringdown service.
I'll give it a shot..thanks again for your advice..

Jack

 

[JediBMC]

To provide you with a little more information, here are the steps:

[ol]
[li]Using the command Change Station XXXX (Where XXXX is the station).[/li]
[li]On tab 3, enter the following in the appropriate fields:[/li]
[ul]
[li]List1: Personal 1[/li]
[/ul]
[li]Save the changes and modify the abbreviated dial list by using command Change Abbreviated-Dialing Personal XXXX (Where XXXX is the station).[/li]
[li]Add the destination extension to the first line in the list. Save your changes.[/li]
[li]Set up the hot-line destination, using the command Change Station XXXX (Where XXXX is the station).[/li]
[li]On tab 3, enter the following in the appropriate fields:[/li]
[ul]
[li]Hot Line Destination | Abbreviated Dialing List Number: 1[/li]
[li]Dial Code: 1[/li]
[/ul]
[li]Save your changes and you are done![/li]
[/ol]

-Brian-
Semper Paratus

 

[Jackman50]

Brian,
Thank you so much for your help..I appreciate it greatly..
This will be very helpful to me...
I'll let you know how it all turns out...

Have a great day!!
Jack

 

[Jackman50]

Hey Brian,
I just wanted to thank you once again. I set up a test station, followed your instructions...and bingo! It worked like a charm...

Thank you sir !
Jack