visionthing
Technical User
Stumped!
Have 1 WIC-1DSU-T1 in slot 0/0 up and working fine. I added another WIC-1DSU-T1 in slot 0/1, config'd the port and recycled. The 1st WIC comes up with both AMBER & GREEN lights and the AMBER goes off (a good thing). The 2nd WIC comes up with both lights on and the AMBER will stay on. I've taken both WICS out and put the 2nd WIC in slot 0/0, recycled and the AMBER light still stays on. Take it out and put the 1st WIC in slot 0/1 and everythings good. I figure BAD WIC and have it replaced. I get the same problem with the replacement! I have it replaced with a 3rd one and it gives the same problem. Just to reiterate, 1st WIC works in both slots, whether there's 1 or 2 WICs in the NM, but the 2nd and it's replacements won't work, even by itself in either slot. I wanted to check here before I replace it again, this time from another vendor.
Have 1 WIC-1DSU-T1 in slot 0/0 up and working fine. I added another WIC-1DSU-T1 in slot 0/1, config'd the port and recycled. The 1st WIC comes up with both AMBER & GREEN lights and the AMBER goes off (a good thing). The 2nd WIC comes up with both lights on and the AMBER will stay on. I've taken both WICS out and put the 2nd WIC in slot 0/0, recycled and the AMBER light still stays on. Take it out and put the 1st WIC in slot 0/1 and everythings good. I figure BAD WIC and have it replaced. I get the same problem with the replacement! I have it replaced with a 3rd one and it gives the same problem. Just to reiterate, 1st WIC works in both slots, whether there's 1 or 2 WICs in the NM, but the 2nd and it's replacements won't work, even by itself in either slot. I wanted to check here before I replace it again, this time from another vendor.
