problem with WIC and 2612

[Wielebny]

Hi

I've got Cisco Router 2612 and i want to install WIC 10BT on it.WIC is MADE IN CHINA unfortunetly :/.

IOS tells me :
%PQUICC-1-UNKNOWN_WIC: PQUICC(0), WIC card has an unknown ID of 0x39

My ios:

IOS (tm) C2600 Software (C2600-DO3S-M), Version 12.2(40a), RELEASE SOFTWARE (fc1
reset system reset
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Sun 11-Mar-07 01:33 by pwade
Image text-base: 0x8000808C, data-base: 0x8128FD14

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

Router uptime is 11 minutes
System returned to ROM by reload
System image file is "flash:c2600-do3s-mz.122-40a.bin"

cisco 2612 (MPC860) processor (revision 0x101) with 39178K/1781K bytes of memory
.
Processor board ID JXXXXX
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 Token Ring/IEEE 802.5 interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102


What is wrong ??

 

[burtsbees]

What is a WIC-10BT?
Anyway, that usually means the wrong IOS...looks like that one supports DECNET and IPX. Have any Novell or VAX, DEC or Alpha servers?
Nothing I have searched even comes up with a WIC-10BT...

Burt

 

[ADB100]

There is a WIC-1ENET which is a single-port 10BaseT Ethernet WIC. I have one in a 1720 router. Check with the feature navigator on CCO as to what router and IOS supports it.

HTH

Andy

 

[Minue]

The WIC-1ENET only supports the 1700 series.

Regards

 

[Wielebny]

So what WIC i need in 2612 to connect another network via Ethernet 10/100 TC/IP or 10 TCP/IP ??

 

[Minue]

Hello
This is t he 10MB model "CISCO NM-1E".There's a 100MB as well but I don't remember the model name.Will check it out and get back to you.
Regards

 

[Wielebny]

I check it and it is NM-1E or NM-1FE-TX and it cost over 100 $ :/