Problem loading IA770 on a S8400/G650

[ccctech]

I recently replaced the S8400 server and reloaded CM4.0.1 but was never prompted to load the IA770 software. It doesn't show the Messaging IP Address when going into Config Server. Also it does show the process at all when going into Process Summary until I load the license, then it allways shows the service as down. I going to reload the software again tomorrow. Should I be prompted to load the IA770 like it does on a S8300? Thanks

 

[Mitch672]

your telnet default is probably to send "crlf" (carriage return line feed), instead of just "cr", so the question probably wizzed by you.. type 'telnet', then 'unset crlf'

mitch

Welcome to Microsoft Telnet Client
Escape Character is 'CTRL+]'
Microsoft Telnet> help

Commands may be abbreviated. Supported commands are:

c - close close current connection
d - display display operating parameters
o - open hostname [port] connect to hostname (default port 23).
q - quit exit telnet
set - set set options (type 'set ?' for a list)
sen - send send strings to server
st - status print status information
u - unset unset options (type 'unset ?' for a list)
?/h - help print help information
Microsoft Telnet> display
Escape Character is 'CTRL+]'
Will auth(NTLM Authentication)
Local echo off
New line mode - Causes return key to send CR & LF
Current mode: Console
Will term type
Preferred term type is ANSI
Microsoft Telnet>
Microsoft Telnet> unset crlf
Line feed mode - Causes return key to send CR
Microsoft Telnet> display
Escape Character is 'CTRL+]'
Will auth(NTLM Authentication)
Local echo off
Line feed mode - Causes return key to send CR
Current mode: Console
Will term type
Preferred term type is ANSI
Microsoft Telnet>

AVAYA Certified Specialist

 

[ccctech]

I thought I used the 'unset crlf'. I was prompted for what type of server, I chose S8400. Then I was prompted for what drive to load, I left it defaulted at the 4G SSD Drive. The other option was the 32G Hard Drive. It warned me any other data on that partition would be lost then start to load as normal

 

[Mitch672]

well, if you where sending "CRLF" for each time the "enter" key was pressed, you only saw 1/2 the questions, that was my point

mitch


AVAYA Certified Specialist