Printing PRI Circut Number from PBX

[Tommy1967]

How can I print or veiw the PRI circut numbers that is servicing the Meridian PBX Option 81. What load and how can I do this? Thanks for you help

 

[jgideon]

If you're trying to find the LEC Circuit ID (what you'd use to verify against billing or report a trouble), they aren't in the PBX. They would be on the label card on the SmartJack/NIU that the T1 cable connects to, or possibly on the cover of the (usually) orange cover on the 66block where the cable from telco is punched down.

 

[janaya]

If they would only allow alpha characters in the TKID field when building a T1, we would all have it a little easier.

John

 

[Tommy1967]

Darn. I guess I have to visit the site tomorrow. Thanks for your quick replies

 

[dlesap]

Try LD 21 LTM command

 

[johnpoole]

about 4 ways to do that. the quickest is ld 60 stat, that list all t1's and pri's.. the pri's are the ones with a * after the trunk.. another way not mentioned is ld 22 prt cequ.. ld 21 ltm, shows all trunks programed, not always a good test since some techs don't leave a switch that clean. another place to check is ld 96 stat dch.. that doesn't show each pri but does show a list of all d channels and there status.. welcome to the club

john poole
bellsouth business
columbia,sc

 

[Tommy1967]

Wow, that's awesome. Thanks Johnpoole & dlesap, It worked.
There is so much that I have learned from this forum. Thanks to all.