I recently changed printers and now when I go to print one specific report the report prints and three blank pages print after it. I am using a pushbutton to print from a form. If I go to the report that is generated in reports and print it using the "print clip to width" command it prints fine. I have tried everything that I can think of I tried to change the pal code in the pushbutton using repInfo with no success. I tried changing the margins of the page with no success. Anyone had this problem and solved it?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Printing extra pages 1
- Thread starter JTimothy
- Start date
-
1
- #2
JTimothy,
Switching printers is often tricky, for you need to make certain that the "unprintable areas" haven't changed.
The easiest way to do this is to reduce the margins (File | Page Setup) of your report and to move objects slightly away from the right and bottom edges of the report.
Also, it sometimes helps to shorten the header/footer bands in the report.
Hope this helps...
-- Lance
Switching printers is often tricky, for you need to make certain that the "unprintable areas" haven't changed.
The easiest way to do this is to reduce the margins (File | Page Setup) of your report and to move objects slightly away from the right and bottom edges of the report.
Also, it sometimes helps to shorten the header/footer bands in the report.
Hope this helps...
-- Lance
- Status
Similar threads
- Locked
- Question
- Locked
- Question