PRI Service

[mplana2]

Hi,

We are currently running G3si V10 and we are on the process on installing an ISDN-PRI line (30 channels). what I think what I just need to configure is configure the DS1 card (add ds1 xxxxx), add a signalling group for the D-channel and create the trunk group. but I read on one of the threads here, thread690-947923 we need to use a processor interface card for ISDN service in G3si systems. can anyone ther confirm if I still need this if I am running G3si V10? our ISDN licenses are enabled. If we need processor interface card can anyone tell me the step by step procedure/configuration to do it and what are the other requirements.

Any help is very much appreciated. Thanks in advance

 

[4merAvaya]

The PI port only applied to G3si systems prior to V7. Make sure that the ISDN-PRI software is active on your switch. Check the Customer-Options page.

Kevin

 

[bhanson184]

4merAvaya is correct you need to make sure you have PRI turned on under "changer system-parameters customer-options". Avaya has to do this. You also need the correct DS1 circuit packs to support the new service.

BHanson