PRI Question?

[notme11]

I was given the task to install an old MICS that has been sitting on a shelf for about 4 years . I powered the thing up and all seems to work fine. I restit the system to defaults?
but i have no idea what software level it is.. the version is 30mdF11 NAT. also I need to know if this software level will support PRI, if so how do I find out if I already have PRI enableler Key codes or if I need to get new ones.
any info is be apreciated.

 

[PERRYPJ]

You have yourself a Rel 3, and no it will not support ISDN

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[exsmogger]

Upgrade your software to at least R6.1MR to support PRI. You would not have a PRI keycode installed at your current release. Doing a RESTART would have wiped it out anyway. You'll also need a digital trunk card, and either a 6-port combo card or a services card to provide clocking for the PRI.

Brian Cox

http://www.jandjcommunications.com

http://groups.to/jandj/

(updated 3-13-09)

http://phonewire.blogspot.com/

(updated 3-13-09)

 

[jerryreeve]

If your LEC has a nortel DMS Central Office Switch then skip 6.1 and go straight to 7.1. 6.1 had some problems with the setup of PRI when connected to a DMS Switch.

----------------------------
Hill?? What hill??
I didn't see any $%@#(*$ Hill!!
----------------------------
JerryReeve
Communication Systems Int'l
com-sys.com

 

[RikRodgers]

I still can't get over that. %-)

 

[notme11]

thanks all
upgraded to 6.1 installed and so far all is good.