Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
PRI Question
- Thread starter dontworx
- Start date
- Thread starter
- #4
RikRodgers
Vendor
I've posted this issue I've had a few times already, but it bears telling again.
MICS 5.0 running PRI clean for 3 years. Cut over to new service provider, and started dropping calls. CO tested clean with tberd on site, and verified config correct.
I upgraded to 6.1MR. Same issue. The KSU was accumulating RAI's, and resetting the card every 10 min., or so, dropping the calls.
As a last resort, I upgraded to 7.1, not expecting any change. Everything started running clean, and has been working fine ever since.
Old provider- 5E switch, New provider- Siemens switch.
MICS 5.0 running PRI clean for 3 years. Cut over to new service provider, and started dropping calls. CO tested clean with tberd on site, and verified config correct.
I upgraded to 6.1MR. Same issue. The KSU was accumulating RAI's, and resetting the card every 10 min., or so, dropping the calls.
As a last resort, I upgraded to 7.1, not expecting any change. Everything started running clean, and has been working fine ever since.
Old provider- 5E switch, New provider- Siemens switch.
- Status
Similar threads
- Locked
- Question
