PRI Installation (DMS-100) 1

[pduarte]

Hello Everyone,
I need some help installing a new Board (TN 767E)
I have a T1 pri from our Telco which is a DMS-100 type ISDN.
I need help in setting up the DS1 board settings.
The setting I have doubt in are as follow:
CONNECT: (network, pbx, line-side, host)
COUNTRY PROTOCOL: (1,2,3,4,...)
PROTOCOL VERSION: (a,b,c,)
I have a Definity G3 Ver 8

I would also like to know how to decode the Status light on the Board.

I have set up my ds1, signal group and trunk group.
but my D-channel is not coming up. Error 8

Thanks for all the help in advance.

 

[lopes1211]

CONNECT: network
COUNTRY PROTOCOL: 1 assuming USA
PROTOCOL VERSION: c

Stat1:
Green - far end loop active
Yellow - BER alarm
Solid Red - loss of signal
Flashing Red - Failed loopback
Off - Normal

Stat2:
Green - CSU repeater loopback
Yellow - Near end CSU loopback
Solid or random flashing red - span alarm
Flashing red - bad 120A CSU
Off - Normal

Stat3:
Green - pulses present
Yellow - BPV from span
Red - CRC from span
off - no pulses

Stat4:
Green - AIS from span
Yellow - remote frame alarm
Red - loss of frame alignment
off - normal -CL

 

[pduarte]

Hello Lopez1211

Thanks for the Information. It has help out tremendously.

I have another question if you don't mind.

Can you give me more information on the Protocol Version.

a = ....
b = ....
c = ....

I now have a link established between the CO and the Definity but cannot TAC into the Trunk.

The CO says everything is ok.

and the ISDN Type they are using is DMS-100 Custom
whatever that means.

Thanks again for the Help

Pablo Duarte

 

[lopes1211]

a - AT&T 4e/5e
b - National
c - DMS

FYI - You cannot TAC into a PRI even if it's working correctly. Jumping onto a random B channel wont work because the D channel has no idea you're accessing a B channel. It doesn't work by design. You should build a route pattern, change ars analysis for a specific test number to use the route pattern, and give it a shot.

-CL