on a dual pri what does the red and yellow led alarm mean.does red mean a problem from the switch and yellow their is a problem with the network.if i loop back to the to the opt 81 what is the correct respones i should get if the problem is in the opt 81 or if the problem is in the network
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
pri card question
- Thread starter blue31
- Start date
bigindian65
Technical User
It can be misleading pending direction it is looking, I have have always had farend Red myside yellow. if you put a local lb in it, it will be green. if both sides of the card are hot, swapp the telco on the back, does it follow the cable? = telco stay on the port? = you.
Mato' Was'aka
Mato' Was'aka
9 times out of 10, it's your carrier. If you loopback to your system, all lights should go green except DCH. You should receive a wrong mode message on your terminal. It will all sync in 5 minutes. If that happens, it's your carriers problem. Make sure you loopback just before the carriers NIU.
DocVic
Dedicated to Nortel Products till the end.
Need help?
DocVic
Dedicated to Nortel Products till the end.
Need help?
- Status
Similar threads
- Locked
- Question