POW-SUP alarm on cabinet that doesn't exist

[mdefedele]

Hey all I have a stack with 2 g650's in it and it has an alarm showing on the e carrier slot 15 which does't exist. I was able to clear the alarm by adding the cabinet and testing environment and then removing cabinet. I saved translations and also ran a reset system 1. The alarm comes back daily even though the cabinet does not physically exist or exist in programming????
This is on a 3.0.1 system. PSN 962U is close but different. Any help is appreciated. Thanks.

 

[Pops57]

I think your close to it, try adding the cabinet, removing the power supply unit in slot 15 then removing the cabinet

 

[Mitch672]

or upgrade to CM 3.1.4, whcih you can do with just the CD, and no additional licnese (CM3 is still CM3). AVAYA is only officially support and going to make patches for CM 3.1.4, and nothing earlier, is what I heard. Time to upgrade that switch to 3.1.4

mitch


AVAYA Certified Specialist

 

[definityandcmuk]

Try Pop57's suggestion first, I have had this issue before and cleared it by adding the none-existent cab, changing circuit packs to remove the power supply and then removing the cab.