port fowarding a range with Nat on 2611

[lpmartineau]

Hello,

I have a Cisco 2611 that I use as my broadband router and to learn cisco stuff. it works Very well and I am very impressed.

I do have one thing that has been nagging at me for a long time now though and I Can't find the answer, I have googled for days and read alot of stuff on cisco's website.

I need to forward a range of ports, for example I need to forward port 2300 to 2400 udp And TCP for FSHOST a flight sim server that is running one of my srevers and I would rather not put 100 ip nat inside source static tcp 192.168.2.xxx port interface Ethernet0/1 port
Entries

thank you very much.

Luc

 

[plshlpme]

i wouldlove for their be a solution to this as well... the only way i got around it was by static natting my wan ip onto a lan address and then into my netgear router.. where i had control in the port ranges... not a very economical solution.. but it was better then inputting hundreds of nat inside source static commands...