Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Port Count
- Thread starter wizardbee
- Start date
If you're looking for RTU, you can do 'display capacity'. On page 9 it will show you station RTU: total, used, & spare.
If you want a physical port count you can do the following:
Using ASA select 'Reports' then type 'list config all' and 'export screen capture to file'.
Use Microsoft Excel to open the saved file. You will need to select 'all' as the file type to
see the save config file.
In spare columns you can enter the board capacity, i.e. TN2224=24, etc., and used ports. Then
let Excel add them up for you.
Beginning in CM 3.x RTU only applies to stations, not trunks.
Kevin
If you want a physical port count you can do the following:
Using ASA select 'Reports' then type 'list config all' and 'export screen capture to file'.
Use Microsoft Excel to open the saved file. You will need to select 'all' as the file type to
see the save config file.
In spare columns you can enter the board capacity, i.e. TN2224=24, etc., and used ports. Then
let Excel add them up for you.
Beginning in CM 3.x RTU only applies to stations, not trunks.
Kevin
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question