Please help..kinda stuck ..cisco switch 2950

[avidos]

i am connecting to a remote switch, through telnet on port 10, which is assigned to vlan 200 and the manegment is ofcourse on the same vlan (200), now how do i switch the port to vlan 1 and switch the management vlan also to 1, with out getting booted off.

any help would be great
thanks

 

[avidos]

i was able to change the port to a trunk, so i can now access the switch from any vlan, tricky part now is changing the management port to 1 from 200 with out getting booted..any ideas

 

[jdeisenm]

I don't see a way you can change the mgmt vlan ip without getting dropped. I changed the mgmt vlan and ip. I got dropped but was able to connect to the new ip address.

 

[NettableWalker]

copy a new config to the start-up config then reboot.

MCP,CCA, Net+, 1 quarter CCNP...

 

[rmcp2k]

Hellbabe read the description!!! he does not want the end user to get drop when changing vlan.

There is no way around it, do it after hour.

 

[vipergg]

If you had a tftp server you could put the modified config on the tftp server then download the config to startup config . then do a "copy start run " and this will put it in the running config , you will still get a blip but it will shorter than doing a reload .