Please Help , Cisco 1721 Router - Multicast - Newbie

[Lukeskywalker377]

Hi,

I am using PIM sparse mode on my router, I can see the multicast data getting to the router when i use " show ip mroute count" , but how do i check where the router is forwarding the data to?

Show IP mroute shows the following

IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report, s - SSM
Outgoing interface flags: H - Hardware switched
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode

(*, 239.88.5.50), 19:57:19/00:00:00, RP 196.26.123.66, flags: SJCL
Incoming interface: Dialer2, RPF nbr 192.168.50.1
Outgoing interface list:
FastEthernet0, Forward/Sparse, 19:57:19/00:02:02

(196.26.123.77, 239.88.5.50), 01:04:01/00:02:10, flags: CLJT
Incoming interface: Dialer2, RPF nbr 192.168.50.1
Outgoing interface list:
FastEthernet0, Forward/Sparse, 01:04:01/00:02:02

(*, 239.88.5.51), 19:57:19/00:00:00, RP 196.26.123.66, flags: SJCL
Incoming interface: Dialer2, RPF nbr 192.168.50.1
Outgoing interface list:
FastEthernet0, Forward/Sparse, 19:57:19/00:02:05


Does this mean that the data is being forwarded to the fastethernet interface and how do i check that????


Pleeeeeeeeeeeeeeeeeeease help me?????

 

[rburke]

"(*, 239.88.5.50), 19:57:19/00:00:00, RP 196.26.123.66, flags: SJCL
Incoming interface: Dialer2, RPF nbr 192.168.50.1
Outgoing interface list:
FastEthernet0, Forward/Sparse, 19:57:19/00:02:02

(196.26.123.77, 239.88.5.50), 01:04:01/00:02:10, flags: CLJT
Incoming interface: Dialer2, RPF nbr 192.168.50.1
Outgoing interface list:
FastEthernet0, Forward/Sparse, 01:04:01/00:02:02

(*, 239.88.5.51), 19:57:19/00:00:00, RP 196.26.123.66, flags: SJCL
Incoming interface: Dialer2, RPF nbr 192.168.50.1
Outgoing interface list:
FastEthernet0, Forward/Sparse, 19:57:19/00:02:05"


Yes, that means the data is being forwarded out hte FastEthernet0 interface:

"Outgoing interface list:
FastEthernet0, Forward/Sparse, 19:57:19/00:02:05"

Burke