As relayed in other posts, I am downsizing a Prologix for a reinstall. There is only room for one cabinet and they only have 40 phones, no network connectivity, no voicemail. I am not reusing the clan. I have a major error PKT-INT on port 01A2, and based on the posts I have read am wondering if it is due to no clan. Any ideas on how to clear it?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
PKT-INT alarm
- Thread starter phonesaz
- Start date
AvayaTier3
Technical User
You don't need a clan for a packet bus. Unplug it.
Commmand: list config board 1a02
there should be nothing but "u" on all the ports
Command: change circuit-pack
blank out the tn799
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
39 years Bell, AT&T, Lucent, Avaya
Tier 3 for 29 years and counting
[URL unfurl="true"]http://bshtele.com[/url]
Commmand: list config board 1a02
there should be nothing but "u" on all the ports
Command: change circuit-pack
blank out the tn799
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
39 years Bell, AT&T, Lucent, Avaya
Tier 3 for 29 years and counting
[URL unfurl="true"]http://bshtele.com[/url]
- Thread starter
- #3
At the bottom of Page 2 of the System Maintenance form there are some entries that need to be changed when a C-LAN board is installed. I believe that the Packet Interface 2 field can be set to 'n' if you don't have a C-LAN board installed.
SPE OPTIONAL BOARDS
Packet Intf1? y Packet Intf2? y
Bus Bridge: 01A10 Inter-Board Link Timeslots Pt0: 6 Pt1: 1 Pt2: 1
Kevin
SPE OPTIONAL BOARDS
Packet Intf1? y Packet Intf2? y
Bus Bridge: 01A10 Inter-Board Link Timeslots Pt0: 6 Pt1: 1 Pt2: 1
Kevin
- Status