is it possible to set filters down to port level, using the Cisco Secure Policy Manager. I can set the filters from the command line, but when I use CSPM, I can only filter to a particular protocol-ftp, tftp, sntp etc. When using Thin Clients/servers I need to be very specific about the port numbers allowed through.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
PIX firewall Access-Lists
- Thread starter kn
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question