PIX 515E - passing traffic between site to site VPN's

[KTFF]

This might be a dumb question to you advanced guys but I just got my CCNA so be patient with me

I have a Cisco PIX 515E at the central site. I have established site to site VPN's with 5 other sites. All sites can pass traffic to the central site with no problems. However I need several of the remote sites to talk to each other as well. From what I have been reading the PIX can not facilitate this as it will not route traffic back out the same interface it came in. Is it simply a matter of needing a router at my central site? Or am I missing something?

 

[Supergrrover]

Here is the config for spoke-to-spoke communication. You will need PIX OS7.x or higher code on the hub pix to be able to do this.

http://www.cisco.com/en/US/products...s_configuration_example09186a00804675ac.shtml

Brent
Systems Engineer / Consultant
CCNP, CCSP

 

[KTFF]

Thanks for the info. My luck being what it is my PIX is on 6.x, so obviously I will need to upgrade.

I am at least glad to see it was not my config, but a limitation of the IOS.

Thanks again!