Ok. I'm trying to connect to a hospital through their VPN software and my firewall won't let me through to their system. I'm pretty new to routers and firewalls. I have spoken to their guys and they say that I have to have IPSec enabled. I told them that, of course, this is no problem. However, I cannot seem to find out how to enable IPSec on the firewall using the GUI. How does one go about enabling IPSec on a PIX 501?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pix 501 IPSec Enabled?
- Thread starter ElClap
- Start date
- Thread starter
- #2
What you are asking about is a bit more complex than just saying humm de dumm... enable ipsec, there done. Abit of configuration is going to go into this.
Not to mention you are in a router forum so a lot of us may not even look at the problem. PIX and routers are not the same animal. Were some of us may be really good with routers we may space out when we think of messing with a pix.
Would say you may want to look at this on cisco web site it may help you out a bit.
Not to mention you are in a router forum so a lot of us may not even look at the problem. PIX and routers are not the same animal. Were some of us may be really good with routers we may space out when we think of messing with a pix.
Would say you may want to look at this on cisco web site it may help you out a bit.
- Status
Similar threads
