mikehall13
IS-IT--Management
When I the printer on after a LONG warmup it gives this error [red]09.037.45:73489[/red]
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 850 error 09.037.45:73489
- Thread starter mikehall13
- Start date
- Status
Mike,
I cannot find that error code you mentioned. The closest thing I can get to is 9,037.42 and this error message is a failure with the ink load assembly. Xerox recommends checking the ink chute ( possibly yellow ). A couple of exact messages from the manual are "Check for a blown F3 fuse on the power supply. If blown, replace the power supply AND the cap/wire/purge assembly. If not blown, replace ink loader" and another message indicated to check the ink loader chute. If there is a block in the chute, a message will be reported 3 times before an ink fault is declared. Are you using 3rd party ink? I hope this helps you if you have not already solved the problem by now.
I cannot find that error code you mentioned. The closest thing I can get to is 9,037.42 and this error message is a failure with the ink load assembly. Xerox recommends checking the ink chute ( possibly yellow ). A couple of exact messages from the manual are "Check for a blown F3 fuse on the power supply. If blown, replace the power supply AND the cap/wire/purge assembly. If not blown, replace ink loader" and another message indicated to check the ink loader chute. If there is a block in the chute, a message will be reported 3 times before an ink fault is declared. Are you using 3rd party ink? I hope this helps you if you have not already solved the problem by now.
- Status
Similar threads
- Locked
- Question
