Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 8400 Fault 37,004,40:16022
- Thread starter ozisc
- Start date
The 16022 is the page count. 37,004.40: The printhead reservior 0 disconnected. The resevior 0 is not drawing the correct current.
AC power supplied by power sources such as uninterruptible power supplies (UPS’s)
or DC-to-AC inverter systems, may not supply enough current to properly power up
the printer. In these cases, the printer may report printhead jet-stack or reservoir
heater disconnect, drum heater, or preheater errors (37,002.47 thru 37,012.48). Verify
the AC power source prior to troubleshooting a printer exhibiting any of these errors.
AC power supplied by power sources such as uninterruptible power supplies (UPS’s)
or DC-to-AC inverter systems, may not supply enough current to properly power up
the printer. In these cases, the printer may report printhead jet-stack or reservoir
heater disconnect, drum heater, or preheater errors (37,002.47 thru 37,012.48). Verify
the AC power source prior to troubleshooting a printer exhibiting any of these errors.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question