Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 7750 - How to enter the Service Menu? 1
- Thread starter vadimbox
- Start date
-
1
- #2
1. From the Main Menu, highlight Troubleshooting and press OK.
2. Highlight Service Tools and press OK.
3. Press the Up and Down buttons simultaneously to enter the Hidden Service
menu.
4. Highlight Run Service Diagnostics and press OK to enter Service Diagnostics.
2. Highlight Service Tools and press OK.
3. Press the Up and Down buttons simultaneously to enter the Hidden Service
menu.
4. Highlight Run Service Diagnostics and press OK to enter Service Diagnostics.
- Thread starter
- #3
Sorry I wasn't thinking:
1. Turn the printer power OFF.
2. Hold down the Back and Information buttons simultaneously and turn the
printer back ON.
3. Continue to hold the buttons until the following message is displayed on the front panel: Service Diagnostics V#.##, Initializing..., and then release the buttons.
1. Turn the printer power OFF.
2. Hold down the Back and Information buttons simultaneously and turn the
printer back ON.
3. Continue to hold the buttons until the following message is displayed on the front panel: Service Diagnostics V#.##, Initializing..., and then release the buttons.
- Thread starter
- #5
Thank you. I`d like erase error, but I don`t understand how this made. Error 30 "Accumulator Belt took too long to find the home position.
In Service menu I go
NWRAM Access -> Clear Tech Rep Fault -> Clear<4-346>
What i need next if i like erase this error?
In Service menu I go
NWRAM Access -> Clear Tech Rep Fault -> Clear<4-346>
What i need next if i like erase this error?
- Thread starter
- #6
- Status
Similar threads
- Locked
- Question
