greystonefoot
MIS
I have a Phaser 360 which has a Call For Service message and a code 05,002:42. Can anyone help me with what this might be. Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 360 Fault Code 05,002:42 1
- Thread starter greystonefoot
- Start date
- Status
-
1
- #2
5,002.42:
"Y-axis position failure, the drum is not where is should be, possibly because the drum position sensor electronics have failed, or because the motor drive or drive belts have failed, or because something is physically blocking the motion of the drum."
Sounds like an ill sensor on the drum to me but I'll leave it with ya, get back if you can't find anything and i'll dig deeper.
"Y-axis position failure, the drum is not where is should be, possibly because the drum position sensor electronics have failed, or because the motor drive or drive belts have failed, or because something is physically blocking the motion of the drum."
Sounds like an ill sensor on the drum to me but I'll leave it with ya, get back if you can't find anything and i'll dig deeper.
- Status
Similar threads
- Locked
- Question