PBX Tie Lines & ANI

[Mattcctech]

Does anyone know if it is possible for a Siemens PBX to sned over ANI across a Tie Line? I am looking be able to display the calling PBX extension when a PBX phone dials to the Aspect.

 

[candrews11]

Yes, I did it in two locations with Hicom 300's. No issue at all.

 

[Mattcctech]

What did you have the framing and codeing set as? Right now it is not being passed with our current configuration.

 

[HardCoal99]

I've got the same issue, but we have Nortel PBXs. Could the issue be with which switch handles the timing?

 

[chris13]

what kind of trunks/protocols do you use?
we use ISDN (E1) Q.SIG to connect Aspect with Hicom 300. It works fine using DSS1 (EuroISDN), too
It works in both directions. Master/slave-config should matter.

 

[HardCoal99]

We use PRIs to connect to our Option 81C PBXs (National ISDN-2, ESF, B8ZS).

 

[McGruff753]

You need a D-channel on the tie line, don't you? In my set-up, I have an Option 11 and a 400R with a tie line, but no D-Channel.

 

[chris13]

Yes, our tie lines have D-channels.
Sorry, don't know about the in-band signaling and cannot test anything now, worked with M1 until 1997...