I passed my test today with 872, I thought I blew it on a simulation question. The part that I didn't get was what command do you use to determine which interface are set to trunking. I thought the "sh vlan" would be the one but some of the ports that weren't listed in that command were no choices. Anybody know the answer?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Passed CCNA
- Thread starter frelaxx
- Start date
- Thread starter
- #4
show interface trunk is the correct answer.... however there are sevral ways to identify these ports....
Some people are like slinkies. Not really good for anything but they bring a smile to your face when pushed down the stairs.
Tek-TIP Member 19,650
![[americanflag]](/data/assets/smilies/americanflag.gif "[americanflag] [americanflag]")
Some people are like slinkies. Not really good for anything but they bring a smile to your face when pushed down the stairs.
Tek-TIP Member 19,650
- Thread starter
- #7
CiscoGuy33
Instructor
frelaxx,
Great job
E.A. Broda
CCNA, CCDA, CCAI, Network +
Great job
E.A. Broda
CCNA, CCDA, CCAI, Network +
- Status
Similar threads
- Locked
- Helpful tip