If your switches are DCS'd together, then you will need to do some fancy ARS routing to accomodate the paging in another building.
If you have tie-trunks between locs, then you must setup a special route pattern in your primary loc.
You need to establish a paging code number in the terminating bldg.: 7700
We use 4 digit dialing. What do you use?
Establish a route pattern as follows:
The route pattern must have the trk grp of the tie-trunk grp in it:
Grp FRL No. Del Inserted
No. Digits Digits
29 0 7 7700
Setup routing in your Uniform Dial Plan:
Matching Pattern Len Del Insert digits Net
2077 4 0 277 aar
Hope this helps
Telcom1