phillip3606
Programmer
Does the BCM400 4.0 page output support dtmf? I will be installing a bogen zone page module and would like to pass dtmf through page output.Is this possible or do I need to use a trunk port.
Thanks
Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Paging Question
- Thread starter phillip3606
- Start date
- Status
endlesswinter
IS-IT--Management
You will need to use a trunk port. The page will not pass the DTMF.
- Status
Similar threads
- Locked
- Question
